Page 1 of 1

JIT Debug Launch Issue

Posted: Mon Jan 17, 2005 11:37 am
by Piers Plowman
On my Win2k SP4 system I cannot use the Ollydbg as a system debugger as when it is set for this I only get errors on trying to open -aedebug.exe

I looked at the key at

HKLM\Software\Microsoft\WindowsNT\CurrentVersion\AeDebug\Debugger

and found the value to be

"C:\toolkit\OLLYDBG.EXE" -AEDEBUG %ld %ld

it does properly? parse the %ld %ld as the Process ID of the target process

Launching it from the commandline as ollydbg -aedebug <procid> also has the same error.

I tried removing the key and recreating it through the JIT options in Olly but the same key value is set.

Any ideas on what is wrong?

TIA

JIT Debug Launch Issue

Posted: Mon Jan 17, 2005 1:20 pm
by focht
Hi,

well that registry key looks fine.
First parameter is process id (PID) and second one is event handle (to be signaled if process is attached).

To test it from command line you need to supply both parameters, e.g.:

ollydbg -AEDEBUG <pid> <event handle>

To test JIT, write some simple program which forces unhandled exception.

Regards

JIT Debug Launch Issue

Posted: Mon Jan 17, 2005 3:10 pm
by Piers Plowman
Thanks for your quick response!

I didn't realize that the second parameter was for the event handle. The application I was envoking the debugger from wasn't passing that parameter and if you launch it from the commandline as I did previously it gives that anomalous error regarding -AEDEBUG.exe

Perhaps the error handling for insufficient/improper command arguments can be made more clear in a future version.

Thanks again! :)