Results 1 to 2 of 2

Thread: Error message in 16 serioes Cisco router.Please help.

  1. #1

    Error message in 16 serioes Cisco router.Please help.


    I have a 16 series cisco router.these are the interfaces available.
    Router16#show ip interface brief
    Interface IP-Address OK? Method Status Protocol

    Ethernet0 YES manual up down

    Serial0 YES NVRAM down down

    01:14:30: %QUICC_ETHER-1-LOSTCARR: Unit 0, lost carrier. Transceiver problem?
    01:15:30: %QUICC_ETHER-1-LOSTCARR: Unit 0, lost carrier. Transceiver problem?

    There is an ethernet port which is not being listed by this command and the error you see just above is continuously being displays.Is this due to the corrupted interface ? Please advise
    I promise that I have read the FAQ and tried to use the Search to answer my question.

  2. #2
    The easiest is going to cisco site and fill the search field with your displayed error.
    There is an example:
    The following logging message appears at 00:40:20: "Unit 0, lost carrier. Transceiver problem?."After the administrator plugs the Ethernet cable into the Ethernet port, the interface comes up. See 00:40:25.
    0:40:20: %QUICC_ETHER-1-LOSTCARR: Unit 0, lost carrier. Transceiver problem?

    00:40:25: %LINEPROTO-5-UPDOWN: Line protocol on Interface Ethernet0, changed state to up
    I hope this is fixing your problem.
    Anyway, that is not a reverse engineering issue, I guess...

    Best regards


Similar Threads

  1. Hacking and patching TP-LINK TD-W8901G router
    By Piotr Bania Chronicles in forum Blogs Forum
    Replies: 0
    Last Post: January 31st, 2014, 05:40
  2. The Feds in my router?
    By Snatch in forum Off Topic
    Replies: 52
    Last Post: July 5th, 2009, 19:33
  3. What's the meaning of this message???
    By yaa in forum OllyDbg Support Forums
    Replies: 5
    Last Post: November 19th, 2002, 07:53
  4. About message formatting on bd
    By vgb in forum Advanced Reversing and Programming
    Replies: 0
    Last Post: February 26th, 2001, 11:45


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts