SoftIce: symbol not defined

[mixxu]

When I type:
bpx getdlgitemtxta
SoftIce says:
Symbol not defined (getdlgitemtxta)

Please tell me what to do. I am really a newbie in cracking but I know some hacking stuff.

Check http://www.programmerstools.com/
for best tools.

[stillnewbie_b]

Quote:

mixxu (06-24-2001 08:55): When I type: bpx getdlgitemtxta SoftIce says: Symbol not defined (getdlgitemtxta) Please tell me what to do. I am really a newbie in cracking but I know some hacking stuff. Check http://www.programmerstools.com/ for best tools.

Hiya,
Please read the FAQ before you post anything here.

[vampirefo]

Quote:

mixxu (06-24-2001 08:55): When I type: bpx getdlgitemtxta SoftIce says: Symbol not defined (getdlgitemtxta) Please tell me what to do. I am really a newbie in cracking but I know some hacking stuff. Try getdlgitemtexta, you left out an e Check http://www.programmerstools.com/ for best tools.

[Uly]

ok go to your softice dir..open winice.dat in notepad or ultraedit whateever u use..scroll down to exports and remove the ;'s before the exp's on each one..not the loads aite? gl ..

ps. reboot afta..

[DudyStuff]

Um, yeah. Another thing. Open whatever .exe your cracking into quikview (It should tell you what dll's it uses) Then (if your running S-ice 3.25 +) run Loader32 (somthing like that) and then from one of the menu's there is a config of s-ice startup. Under one of the tabs you can select which dll's to load on startup. Then you can use symbols associated with them Common dll's are User32, Kernel32 Commdlg(i think i spelt it right) etc.

Hope that helps
Write back